C and CFR Form Overall performance Information

C Variety Flex-Flex Couplings
The C Style coupling includes two flex hubs, one particular sleeve and one particular accessory kit consisting of seals and snap rings.
CFR Kind Flex-Rigid Couplings
The CFR Style coupling consist of one flex hub, one rigid hub, one particular sleeve, one accessory kit consisting of seals and snap rings.
Features
Very simple and inexpensive kind of gear coupling
All steel sleves and hubs
Reinforced rubber seals with snap rings to hold lubricant in area
Out there as vertical and horizontal couplings
Broad number of distinctive variations including full-flex, flex-rigid mill motor
Typical configurations can be found on the shelf
Ordering Information and facts
Application: Driver and Driven.
Variety and dimension of coupling, horizontal, vertical etc.
Power: Motor horspower or torque necessity.
Velocity: Motor RPM or Driven RPM.
Distance in between shaft ends (BSE).
Shaft sizes.
C and CFR Type Couplings
Ordering Data
Puller Holes are conventional on sizes 4 by way of 12.
Puller Holes can be found for sizes 7/8 by 3.5 at an extra charge.
The BSE (distance Involving Shaft Ends) may perhaps fluctuate among G and G1.
Interference bores without any set screws are standard unless of course otherwise specified.
Inch bores and keyway tolerances conform to ANSI / AGMA 9002-B04.
For metric bores and keyway tolerances, check with Engineering Area.
Bigger sizes are available, please seek the advice of Technical Support.